STC
Open Impeller Centrifugal Pumps开式叶轮离心泵

原装进口

STC单叶轮泵
该泵低扬程的特性使得它特别适用于农业用途。本泵型用于灌溉以及几乎所有要求高流量低扬程的场合。每台泵在组装后根据ISO9000标准的质量要求进行液压与电气试验。
STC single impeller centrifugal pumps with low delivery pressure are specially conceived for agricultural applications. This type of pump is necessary in sliding irrigation and in general in all those applications where high flow rates at low delivery pressures are required. At the end of assembly each pump is hydraulically and electrically tested in accordance with ISO9000 quality requirements.

结构特征Construction Features
 泵壳及电机支撑：铸铁
Pump casing and motor bearing: cast iron
 叶轮：功率在1.2HP以下用NORYL工程塑料；功率在1.2HP以上用黄铜或铸铁
Impeller: noryl GFN2 up to1.2HP drop-forged brass or cast iron over 1.2HP
 轴：不锈钢
Shaft: stainless steel
 机械密封：石墨-陶瓷
Mechanical seal: carbon-ceramic
 电机：闭式外部风冷型，保护等级IP54
Motor: closed ventilated external, protection IP54
 单相电机装有预置热保护装置及固定联接电容
Single-phase version equipped with built-in thermal protector and permanently connected capacitor
 三相电机不带热保护装置，建议用户自行安装
Three-phase version not equipped with protector; we suggest users to install a protection device
 绝缘等级：F级
Insulation: class F
 二级感应电机：50Hz (n=2900 l/min)
2-pole induction motor, 50Hz (n=2900 l/min)
 可持续工作
Continuous working

运行条件Operating Conditions
 清洁或适度脏水clean or moderately dirty liquids
 液体温度：1.2HP以下不高于45℃，1.2HP以上不高于90℃
Liquid temperature: maximum 45℃ up to 1.2HP; maximum 90℃ over 1.2HP
 环境温度：不高于40℃
Ambient temperature: up to 40℃
 允许最大工作压力：6bar
Maximum permissible working pressure: 6 bar

按客户要求，可提供特殊性能Special Features on Request
 特殊电压 special voltages
 60Hz 频率 frequency 60Hz
 防护等级 IP55 protection IP55
 特殊机械密封 special mechanical seal